OPSX
Guide · 5 min read

Gate attendance when 200 people arrive at once

By , Founder & System Architect · Published

Work out the queue before you buy anything. Multiply the people arriving by the seconds each one takes to mark, divide by the marking points, and compare that with the minutes you have before the shift starts. Then plan for a power cut at 6 am, the moment it would hurt most.

The queue arithmetic

A gate queue is simple maths. Count the people who arrive in the busiest window, time how long one person takes at the device, and see how long the last person waits.

Say a plant in Bihta has 200 workers on the morning shift and most of them arrive between 5:45 and 6:00. If each person takes 6 seconds at the device, one marking point needs 1,200 seconds, which is 20 minutes. The last person in line marks at 6:05 or later and is late through no fault of his own. With three marking points, the same crowd clears in about 7 minutes.

Seconds per person1 marking point2 marking points4 marking points
3 seconds10 minutes5 minutes2.5 minutes
6 seconds20 minutes10 minutes5 minutes
10 seconds33 minutes17 minutes8 minutes
15 seconds, with retries50 minutes25 minutes12.5 minutes

Time it at your own gate

The seconds per person are the number that matters, and brochures do not give you the real one. Stand at the gate with a phone stopwatch for one shift change and time twenty people from the moment they reach the device to the moment they walk away.

  • Face recognitionFast when the light is steady and the person stops and looks. Slow when the sun is behind them at 6 am or they are wearing a helmet or a cloth over the face.
  • FingerprintFast for clean hands. Retries pile up for loaders, masons and mill workers with worn or dusty fingers.
  • Code and PIN on a tabletSteady but slower, since each person types two numbers. Faster once people know them by heart.
  • Card or tagVery fast, but cards get lent, lost and left at home. Proves the card, not the person.

How many marking points you need

Use the table above with your own timed seconds. Aim for the busiest window to clear in well under the grace time you give for late marks. If you allow five minutes of grace, the queue should clear in three, so a slow day still fits.

Then add one more point than the arithmetic says. A device will hang, a tablet will need charging, a supervisor will need one for a correction. A spare point costs far less than a crowd of workers marked late, or a crowd that walks past without marking at all.

Spread the crowd before buying more devices

  • Open marking earlierLet people mark from 15 or 20 minutes before the shift. The crowd that arrives early marks early, and the queue at the last minute shrinks.
  • Stagger shift start by departmentPacking at 6:00, production at 6:15, loading at 6:30. The gate sees three small crowds instead of one big one.
  • Separate in and outPut the outgoing night shift on a different device or a different side of the gate, so 200 arrivals do not meet 200 departures at one tablet.
  • Bring the bus timing in lineIf a company bus brings 60 people from Patna at once, open an extra marking point just for that arrival.
  • Keep supervisors off the gate deviceCorrections, visitor entries and enquiries go to a separate desk, not the queue.

When the power or network fails at 6 am

A power cut or a dead network at shift change stops the whole gate at once. Plan for it in three layers, and test each one before you rely on it.

  • PowerEvery device on a UPS or an inverter line, or a tablet with its own battery kept charged overnight. A device that dies with the mains is useless exactly when you need it.
  • NetworkThe device should store each mark with its own time when the internet is down and send it later. Ask the vendor to show this with the router switched off, and check the stored times match the clock.
  • Device failureIf every device is down, the guard writes names and times in a bound register with page numbers, and the supervisor signs it. Those entries are typed in later as corrections, with a reason, not quietly added.

Place the devices well

  • Under a roof, out of the sunGlare on a screen or behind a face slows every person in the line. Rain on a tablet ends the day.
  • Inside the gate, not outsideMarking should happen where the guard can see, so nobody marks and walks back out to the tea stall.
  • At a comfortable heightA face device set too high or too low means people bend and adjust, which costs seconds.
  • With space for a lineA straight queue with room on both sides. A crowd in a narrow gate slows everyone and hides proxy marking.
  • Clear confirmationA name on screen and a sound, so the worker knows the mark went in and does not try again.

Grace time and late marks during a rush

If the queue regularly runs past shift start, your late marks are measuring the gate, not the workers. Fix the queue first. Until then, either set the grace time to cover the real queue, or count arrival from the time the person joined the line, which only a guard can confirm.

Watch the first two weeks of records closely. A sudden jump in late marks on one day usually means a device or a power problem, not a crowd of lazy workers, and should not cut anyone's pay.

Where OpsX fits

One Android tablet at the gate. Each person enters their employee code and PIN and sees a clear confirmation on screen. The kiosk keeps working when the internet does not, and every punch reaches attendance and payroll. See OpsX Kiosk.

Questions

How many attendance devices does a factory gate need?

Time how many seconds one person takes, multiply by the people arriving in the busiest window, and divide by the minutes you want the queue to last. Add one spare device on top of that number.

Is face recognition faster than fingerprint at a factory gate?

Often, because there is no retry for dusty or worn fingers. Light matters, though: test it at your own gate at shift-change time, with the morning sun, before you decide.

What happens to attendance if the internet is down at shift change?

A suitable device stores each mark with its original time and sends it once the network returns. Ask to see this with the router switched off before you buy.

Should the night shift leaving and the morning shift arriving use the same device?

Better not. Separate in and out on different devices or sides of the gate, so two crowds do not meet at one queue.

Related product
OpsX Kiosk →

No card needed. ₹0.75 per active employee per day after the 51-day free trial, billed monthly with a GST invoice.

More from OpsX